Meet the Keenon C40: A 4-in-1 Cleaning Robot Built for Real-World Spaces
The Keenon C40 sweeps, vacuums, dust mops and scrubs on its own, covering up to 1,100 m² an hour. It is built for the spaces that big industrial scrubbers can’t reach and small consumer robots can’t handle: offices, clinics, hotel lobbies, retail floors and schools.
In these spaces, floors mix carpet and hard surfaces, corridors are tight, and people are always walking through. Here is how the C40 is designed to deal with all three.
Four jobs, one machine
One robot replaces a rotation of separate tools. The C40 runs five modes:
- Sweeping for loose debris, with double side brushes widening the path to 560 mm
- Vacuuming (sweep + vacuum) for carpet and hard floor, into an 8 L dust bag
- Dust mopping (sweep + dust mop) for fine dust on hard surfaces
- Scrubbing (sweep + scrub) for wet cleaning, fed by a 16 L clean water tank
- Water extraction to pull standing water off the floor
The key to switching between dry and wet work is Keenon’s triple-brush dry/wet separation system. Dry debris and dirty water travel separate paths, so they never mix. That means no muddy slurry in the dust bag and no clogged wet system, and the robot can move from vacuuming to scrubbing in one step.
Dry floors seconds after scrubbing
Wet floors are a slip hazard and a reason to rope off an area. The C40’s answer is 23,500 Pa of suction, strong enough to leave the floor dry within seconds of scrubbing, with no water residue.
That suction pulls dirty water into an 11 L wastewater tank. The tank is fully removable and washable, so it can be rinsed out properly after each shift instead of building up odor and bacteria.
Built to work around people
The C40 is meant to clean during business hours, not just after everyone leaves. To do that safely, it fuses data from several sensor types:
- LiDAR for mapping and positioning, with a detection range of up to 40 m
- Stereo vision sensors with 170° horizontal coverage
- Line laser and ultrasonic sensors for close-range and low-lying obstacles
- VSLAM, an IMU, an RGB camera and a collision sensor to round out the picture
Keenon’s navigation and obstacle-avoidance software combines these into centimeter-level positioning, tuned for spaces shared with people.
The footprint helps too. The robot is 616 × 550 × 690 mm and fits through gaps as narrow as 65 cm and under clearances as low as 75 cm. It crosses 35 mm gaps, climbs 15 mm thresholds when navigating or vacuuming, and handles low-pile carpet up to 10 mm.
Long runtimes, and swaps instead of waits
The C40 runs on a 25.6 V, 50 Ah LFP (lithium iron phosphate) battery. Runtime depends on the job:
| Mode | Runtime (up to) |
|---|---|
| Sweeping | 15 h |
| Dust mopping | 10 h |
| Vacuuming | 6 h |
| Scrubbing | 5 h |
A full charge takes about 2 hours. For sites that can’t afford that downtime, the battery is quick-swappable: drop in a charged pack and the robot is back at work with almost no interruption.
Charging works two ways. A bundled charger handles manual charging, and an optional charging pile (sold separately) lets the robot dock and recharge itself, then resume where it left off.
Easy to run, easy to maintain
Staff don’t need training in robotics to use the C40. Setup and daily use run through an 11.6-inch HD touchscreen (1920 × 1080), with light, touch and voice prompts. A rear-tilting control panel lets an operator stand behind the robot and drive it manually for spot cleaning.
Routine upkeep is designed to be fast. Side brushes, the dust bag and both water tanks are quick-switch consumables, and the brushes sit on rails that slide out for cleaning.
For managers, the Keenon mobile app and Keenon Cloud handle the rest:
- Immediate, scheduled and manual cleaning, plus a teaching mode for new routes
- Breakpoint resumption, so an interrupted job picks up where it stopped
- Auto-recharging and multi-robot coordination across a site
- Connectivity over Wi-Fi or 4G, with the app in Chinese, English, Japanese, Korean, French, Thai and German
C40 at a glance
| Spec | C40 |
|---|---|
| Cleaning efficiency | Up to 1,100 m²/h |
| Cleaning area per run | Up to 3,000 m² vacuuming; 2,500 m² scrubbing |
| Cleaning width | 560 mm sweeping; 400 mm vacuuming and scrubbing |
| Suction | Up to 23,500 Pa |
| Dust capacity | 8 L dust bag + 0.7 L dustbin |
| Water tanks | 16 L clean, 11 L dirty |
| Max speed | 0.8 m/s (1.2 m/s planned via future upgrade) |
| Noise | 70 dB |
| Slope | Up to 2° while cleaning; 8° navigation only |
| Size and weight | 616 × 550 × 690 mm; 70 kg (with battery, tanks empty) |
| Operating conditions | Indoors, 0–40 °C, 20–80% RH |
| Materials | ABS and aluminum alloy |
Is the C40 right for your space?
The C40 fits best where floors are mixed, spaces are 1,000–3,000 m², and cleaning has to happen around people. Think office floors, healthcare waiting areas, hotel lobbies and corridors, retail stores, and school buildings.
It is less suited to large warehouses, steep ramps or deep-pile carpet. Cleaning slopes top out at 2°, and carpet handling is rated for low pile up to 10 mm.
If your team spends hours each day pushing separate sweepers, vacuums and scrubbers, the C40 can take that routine work off their hands. Contact us to book a demo and see it clean your floors.
